A.G.E. SERIES
FOR NON-FERROUS
TCG Negative Hook Angle (Triple Chip Grind set on 5" negative book)
Application: For profiles and sheets of aluminum and plastics on chop-miter saw and table saw. The negative hook prevents filling in the gullets.
Tool No. Price   Dia.
Teeth
 Kerf Plate Bore
MD10-805 70.28 10" 80 .126 .102 5/8"
MD10-105 76.02 10" 100 .126 .102 5/8"
MD12-105 93.35 12" 100 .126 .102 1"
MD12-105-5/8 93.35 12" 100 .126 .102 5/8"

NOTE: Due to the rough applications for which these blades may be used, they are not guaranteed.
*WARNING: Demolition blade is not to be used on multi-purpose cutoff saws or gas power saws, unless saw has a guard that covers both the upper half and the lower half of the blade completely. The guard must extend to the lowest point of the cutting teeth on the bottom of the blade. Consult owners manual of the saw & follow all instructions and safety procedures - including wearing safety goggles at all times while working with this blade.

© 2003 Amana Tool Corporation. All Rights Reserved

Connecticut Saw & Tool
140 Avon Street, Stratford, CT 06615
Phone: (800) 404-1220 Fax: (203) 378-7346 EMail: Info@CTSaw.com